Bitumen Roofing Sealant

Single-component roofing sealant

Application:

Sealing of coverings made of bituminous felt, shingles, sheet metal, roofing tiles
Sealing of gaps around flashings, chimneys, eaves, wind braces, drains, skylights, roofing felt coverings
Filling of cavities in bituminous felt coverings
Carrying out roofing repairs (removing blisters, sealing cracks and seams in bituminous felt)

Properties:

Available packaging:

Composition	insulation asphalts, dearomatised solvent, fibres, additives
Colour	black
Consistency	plastic paste
Density	1,4 - 1,5 g/cm³
Drying time	approx. 1 mm/day
Flowability at temperature (60 ± 2)°C and inclination of 45° after 5 hours - roofing felt bonded with asphalt binder	unacceptable mass flow
Flexibility when bending on a roller with a diameter of 30 mm at temperature -5°C	no scratches or cracks
Pensky-Martens flash point	no less than 40°C
Water content	no more than 0,5% (m/m)
Penetration (23°C)	min. 190 [0,1 mm]
Drainage on an aluminium sheet at a temperature of 70°C, at a 90° angle, in 5h	not more than 5 mm
Adhesion to concrete: - at a temperature of +23°C, at an elongation of 30 mm - at a temperature of -20°C, at an elongation of 15 mm	does not detach from the substrate does not detach from the substrate
Formation of shrinkage cracks after 30 days at a temperature of 23°C	no cracks and no detachment from the substrate
Thermal resistance after curing	from -20°C to +80°C
Application temperature	from +5°C to +40°C
Reference document(s)	PN-B-24620:1998; PN-B-24620:1998/Az1:2004

The temperature of the substrate and air during the works should be from +5°C to +40°C.
Works should not be carried out during precipitation and strong sunlight.
Apply Bitumen Roofing Sealant with a squeezer.
Pay particular attention to the method of filling the gap. The sealant must continuously adhere to the substrate in the area to be sealed. When gluing or regluing, apply the sealant on one side over the entire surface of the element to be bonded. Wait 15 - 20 minutes, join and press the glued elements down. Cut the blisters crosswise, glue underneath and then brush over with the adhesive on top.
Before use, please read the application details in the product's Technical Data Sheet.