Connect Tape

Needled non-woven fabric

Application:

Installing roof flashings in a system with NEXLER Connect
Reinforcing and ensuring the continuity of waterproofing when connecting various materials including bituminous felt and coatings, metal sheets (including coated and acid-resistant sheets), concrete, hard PVC, wood-based panels
Reinforcing flexible insulation at corners, edges, pipe penetrations etc.
Connecting deformable and non-deformable surfaces

Properties:

Available packaging:

Composition	90% polyester, 10% polypropylene
Width	100 mm or 300 mm
Total thickness	0,70 mm ± 0,1 mm
Mass per unit area	110 g/m² ± 10 g/m²
Mechanical properties in tension (longitudinal direction): - tensile strength - elongation at break	> 150 N / 50 mm > 70%
Mechanical properties in tension (transverse direction): - tensile strength - elongation at break	> 125 N / 50 mm > 50%
Colour	white

Prepare the substrate as recommended in the Technical Data Sheet of NEXLER Connect.
Check the production date on the packaging before use. Do not use the product beyond its shelf life. Check that NEXLER Connect Tape is the same width throughout its entire length. The tape must be uniform along its entire length, without visible mechanical damage, deformation or delamination. The tape must be dry, free from grease, oil and other substances or contaminants that reduce the adhesion of the sealant.
Apply NEXLER Connect evenly to the prepared substrate. NEXLER Connect Tape should then be embedded into the fresh compound by pressing down with a dry tool and then immediately covered with another even layer of product. Then, once the compound has dried, the third layer can be applied. The application area should be defined in such a way that it is at least 4 cm wider on each side than the width of the NEXLER Connect Tape used.
Before use, please read the application details in the product's Technical Data Sheet.

Documents for download